Parts for DCN/DCR Series Cam Locks

DCNP-500-ARP Cam lock stabilizer plate Included with each DCN/DCR series cam lock Keeps the cam lock from rotating in the after installation Place a screw in the center hole to keep the fixing nut from coming loose
DCNP-300-FP Finger pull for cam locks Eliminates need for a wire pull Mounts in front of cam lock between face of cam lock and face of cabinet Face of cam lock holds the finger pull in place Does not require any additional screws Available separately
DCNP-100-BC Bent cam Included with each DCN/DCR series cam lock
DCNP-100-BC5 Bent cam with 1/2" offset Available separately
DCNP-100-LC Long 3' straight cam Available separately
DCNP-100-LBC Long offset cam Available separately
DCNP-100-WB Short straight cam Overall length 1-1/2" Available separately
T37DC-NP Number plate Allows for stamping on ring instead of face of lock Facilitates rekeying of locks without having to overstamp face of lock
DCNP-200-OCD Cam shifter for lost motion - key removable in locked and unlocked positions Included with each DCN/DCR series cam lock
DCNP-200-KR Cam shifter for key removable in locked position only For drawer function only Available separately
DCNP-200-KDR Cam shifter for key removable in locked position only For door function only Available separately

Copyright © 2008 Olympus Lock, Inc. all rights reserved. Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.